使用研磨平板研磨要注意的几个问题
时间：2016/2/25 10:21:41
浏览量：1068
使用研磨平板研磨要注意的几个问题
在研磨平板上研磨工件是个相对细心和繁琐的工作，正是因为这样，很多高端零件也是通过这种方法获得的，例如导弹上的某些零件等。但是研磨时要注意一些问题。
1、要选用好的研磨粉，工作场所要清洁，以免工件表面被刮毛。
2、掌握好研磨的速度和研磨的压力；对准确度高和形状复杂的表面，研磨速度应该低一些。研磨压力大小由工件材料和磨
具材料的性质等因素决定的。研磨压力为0.15~0.2MPa时研磨效率最高。
3、研磨时，一般先用较大压力和较低速度进行粗研，几何形状基本合格后，再用较小压力和较高速度精研。
4、选用合适磨具，以免磨具耗损太快。
Several
Problems to Be Noticed in Using Grinding Plate
Grinding
workpieces on a grinding plate is a relatively careful and cumbersome work.
Because of this, many high-end parts are also obtained by this method, such as
some parts on missiles. But we should pay attention to some problems when
grinding.
1. Choose good
abrasive powder and clean the workplace so as not to scratch the surface of the
workpiece.
2. Grasp the
speed and pressure of grinding well. For the surface with high accuracy and
complex shape, the speed of grinding should be lower. The grinding pressure is
determined by workpiece material and grinding.
It is
determined by the nature of materials and other factors. When the grinding
pressure is 0.15-0.2 MPa, the grinding efficiency is the highest.
3. When
grinding, roughing is usually carried out at a higher pressure and a lower
speed. After the geometry is basically qualified, finishing is carried out at a
lower pressure and a higher speed.
4. Choose
suitable abrasive tools to avoid abrasive wear and tear too fast.
Company name: botou zhuoyuan mechanical equipment manufacturing co.,LTD
Registered
address: jiaohe development zone, botou city, hebei province
Fax
number: 0317-8031093
Contact
information: 15369812793 (WeChat with the same number) liansheng chu
Postcode:
062151
Enterprise
email:
1358827475@qq.com
Account
Opening Bank: Botou Branch of Bank of China
Account
number: 100399943203
Agricultural
bank account number: 6228481739059615270
http://zhuoyuanjixie.com